Aftermarket back plates..

sdmc530 · #1 01-04-2018, 09:41 PM

Nope. Never had an issue and I use one stock back plate and one custom. Both are using mostly factor extractors and “guts”. The back plate should not effect it at all I don’t thimk actualy.

Either spring issues or limpo wrists maybe. Not an issue I have ever had with a

so I might not be the best opinion either.

sdmc530 · #2 01-04-2018, 09:48 PM

https://gastatic.com/blog/wp-content...te-chamber.jpg

Backplate will not effect your extractor issue according to our armored. He said the extractor could be damaged or bent or warn so it’s not a back of slide functioning issue at all. Check you springs and slide action and see if that isn’t it if the extractor is looking normal. Also make sure your ejector is proper. That might also be the cause. Easy to bend that little finger if not careful.

You don’t lube up in there do you?

Pirate · #3 01-04-2018, 10:16 PM

I replaced the extractor as it was worn. Only had one issue so it could have been me. The springs seem fine as I don't think I even have 2k rounds through it.

sdmc530 · #4 01-04-2018, 10:32 PM

Quote:

Originally Posted by Pirate

I replaced the extractor as it was worn. Only had one issue so it could have been me. The springs seem fine as I don't think I even have 2k rounds through it.

2k is nothing so run it and see if it’s fixed. Weird that the extractor was bad that fast though. Might have had a bad one?

pitor · #5 01-07-2018, 10:42 AM

Quote:

Originally Posted by sdmc530

2k is nothing so run it and see if it’s fixed. Weird that the extractor was bad that fast though. Might have had a bad one?

This, the extractor should be good for a couple of Thousand rounds minimum, unless you're shooting a lot of Steel case ammo, in which case it does beat up the extractor pretty badly needing replacement sooner than later.