COTEP.org  

Go Back   COTEP.org > Firearms > 1911 Style Pistols > Mimber

Reply
 
Thread Tools Display Modes
  #1  
Old 10-08-2015, 06:12 PM
DrHenley's Avatar
DrHenley DrHenley is offline
Founding Member
COTEP Member
 
Join Date: Jun 2011
Location: Columbus, GA
Posts: 3,634
Thanks: 68
Thanked 812 Times in 217 Posts
Default A MIM-Rock

Frankenstein half MIMber, half RIA



I got a Mimber compact 22 conversion slide for my compact RIA. The full length Member slide was problematic, which I won't go into now, but I figured the compact slide would be lighter and cycle better...

AND IT DID!

The thing runs like a Singer! I had one failure to extract which was caused by an obvious squib, but other than that it ran through a couple hundred rounds like a champ right out of the box. No fitting required. And was surprisingly accurate. It shot dead on to point of aim at 10 yards.

With my ears getting old and suffering from Tinnitis and hearing loss in my left ear, I needed some way to practice with a compact 1911 that didn't hurt my ears. This is a companion piece to my Sig Ultra, which I dearly love, but which is real hard on my ears with full loads, even with double hearing protection (maximum rated plugs and muffs)

So I run through the plate racks, practicing my draw with the 22 for a while and then switch over to the Sig for a couple of mags. I have been doing this with the full length 22 slide, but it didn't have the same balance as the Ultra, and feel the same drawing. I now have an ultra compact 22 1911 that is as close to the same weight and size to the Sig Ultra as I can get. (Sig has aluminum frame, steel slide, MIM-Rock has steel frame, aluminum slide)

Here is the Sig for comparison:


__________________
Jim
CBOB0497

"That rifle hanging on the wall of the working class flat or laborer's cottage is the symbol of democracy. It is our job to see that it stays there."
- George Orwell

Last edited by DrHenley; 10-08-2015 at 06:17 PM.
Reply With Quote
The Following 5 Users Say Thank You to DrHenley For This Useful Post:
Caleb (10-09-2015), NAMVET72 (01-14-2016), pony up (10-25-2015), sdmc530 (10-08-2015), skosh69 (10-08-2015)
  #2  
Old 10-08-2015, 06:14 PM
sdmc530's Avatar
sdmc530 sdmc530 is offline
Founding Member
COTEP Member
 
Join Date: Nov 2011
Location: South Dakota
Posts: 15,017
Blog Entries: 3
Thanks: 4,511
Thanked 2,790 Times in 732 Posts
Default

nice, glad you could class up the kimber with a ROCK!
__________________
Reply With Quote
  #3  
Old 10-08-2015, 07:38 PM
skosh69's Avatar
skosh69 skosh69 is offline
Founding Member
COTEP Member
 
Join Date: Apr 2011
Posts: 11,000
Thanks: 2,242
Thanked 4,520 Times in 1,212 Posts
Default

That's pretty kewl.
Reply With Quote
  #4  
Old 10-08-2015, 08:38 PM
Riverpigusmc's Avatar
Riverpigusmc Riverpigusmc is offline
Founding Member
Super Moderator
 
Join Date: Aug 2011
Location: Archer, Florida CSA
Posts: 12,992
Blog Entries: 6
Thanks: 1,961
Thanked 3,490 Times in 718 Posts
Default

I like it
__________________
NRA Life Member
Wilson Combat CQB
Kimber Tactical Pro II
S&W J-Frame .38
ect
" I don't own the clothes I'm wearin', and the road goes on forever "

There's a gator in the bushes, and it's calling my name...
COTEP #523
Reply With Quote
  #5  
Old 10-09-2015, 02:05 PM
DrHenley's Avatar
DrHenley DrHenley is offline
Founding Member
COTEP Member
 
Join Date: Jun 2011
Location: Columbus, GA
Posts: 3,634
Thanks: 68
Thanked 812 Times in 217 Posts
Default

BTW, after waiting forever for someone to get this in stock, I finally ordered the slide online from Kim... uh, I mean, MIMber. Took about a week.

http://store.kimberamerica.com/handg...onversion-kits

__________________
Jim
CBOB0497

"That rifle hanging on the wall of the working class flat or laborer's cottage is the symbol of democracy. It is our job to see that it stays there."
- George Orwell
Reply With Quote
  #6  
Old 10-09-2015, 02:53 PM
sdmc530's Avatar
sdmc530 sdmc530 is offline
Founding Member
COTEP Member
 
Join Date: Nov 2011
Location: South Dakota
Posts: 15,017
Blog Entries: 3
Thanks: 4,511
Thanked 2,790 Times in 732 Posts
Default

I had a .22 full size model, shot well, liked it but was picky about ammo so sold it. Kind of wish I still had it now though.
__________________
Reply With Quote
  #7  
Old 10-09-2015, 02:59 PM
brownie's Avatar
brownie brownie is offline
COTEP Member
 
Join Date: Jul 2014
Posts: 912
Thanks: 34
Thanked 203 Times in 54 Posts
Default

Nice Franken 1911 22. Glad it runs good for ya
__________________
Quick Kill Pistol

https://www.youtube.com/user/azqkr

"The mind is the limiting factor"
Reply With Quote
  #8  
Old 10-09-2015, 04:19 PM
Caleb's Avatar
Caleb Caleb is offline
COTEP Member
 
Join Date: Sep 2013
Location: Earth
Posts: 11,463
Thanks: 4,192
Thanked 1,137 Times in 254 Posts
Default

That looks sweet!!
__________________
**I have been Enlightened**
Reply With Quote
  #9  
Old 10-24-2015, 10:49 PM
DrHenley's Avatar
DrHenley DrHenley is offline
Founding Member
COTEP Member
 
Join Date: Jun 2011
Location: Columbus, GA
Posts: 3,634
Thanks: 68
Thanked 812 Times in 217 Posts
Default

I ran the MIM-Rock in a steel match this morning. The first stage was a disaster, but it was the ammo . AutoMatch used to be great but this box was misfiring and failing to cycle the action. I switched to a different gun for the second stage, and it got even worse.

So I switched to Armscor ammo and they ran flawlessly until I ran out. Then I broke out the Mini-Mags and they ran flawlessly too. (I usually save those for tree rats) Then after the match, I ran some plate racks with various ammo, and even the usually terrible Remington Thunderbolts ran great. I have a lot of AutoMatch, so I'm hoping it was just that one box.

On the close targets I was keeping up with the race guns with some times less than 2 seconds. I was having some trouble hitting the smaller and farther targets though.

__________________
Jim
CBOB0497

"That rifle hanging on the wall of the working class flat or laborer's cottage is the symbol of democracy. It is our job to see that it stays there."
- George Orwell
Reply With Quote
Reply




All times are GMT -4. The time now is 06:58 AM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.