|
|
| Register | Forums | Blogs | Today's Posts | Search | Donate |
 |
 |
 |
|
#1
08-19-2012, 01:55 PM
|
||||
|
||||
Plunger Tube a little loose
I have noticed each time that I break my PM-1S down for a thorough cleaning that the plunger tube is slightly loose. Is this the way it should be?
It never seems to get looser, it just wiggles a very small amount. Looks like it is staked from the inside of the frame, so my guess is it would be a gunsmith repair if needed. My only 1911, so I don't have any knowledge about this. 
|
|
#2
08-21-2012, 06:44 PM
|
|||||
|
|||||
 , if it's a little loose and hasn't gotten any looser, one of two things happened. Either it wasn't staked correctly at the factory or the staking tubes are a little short. Take it to a good Gunsmith and try to get it restaked, if that doesn't work, a new one isn't very expensive.
__________________
Diligentia, Vis, Celeritas COTEP#CBOB0428 NRA,GCA,OGCA, USAF,Msgt.(Ret.)
|
|
#3
08-22-2012, 11:14 AM
|
||||
|
||||
|
Thanks, it has not gotten any worse, and it's pretty minor. I'll keep an eye on it.
|
Linear Mode
