|
|
| Register | Forums | Blogs | Today's Posts | Search | Donate |
 |
 |
 |
|
#11
10-25-2015, 02:21 PM
|
|||||
|
|||||
If the bore sight dot is HIGH you need to move front sight UP to move POI-point of impact down.
If I read your post correct? Remember move rear sight in direction you want POI to go Move front sight in OPPOSITE direction you want POI to go. You say dot high sight all the way down. You're moving it the wrong way. Is this a matched set of sights, same maker? Or mismatched set? If it's a matched set you should be able to zero them unless something else is wrong? 
|
|
#12
10-25-2015, 03:24 PM
|
|||||
|
|||||
|
Quote:
__________________
**I have been Enlightened**
|
|
#13
10-25-2015, 03:26 PM
|
|||||
|
|||||
|
What distance are you checking it at?
__________________
CBOB0716 "The most basic right that we have emanates from our Creator and it is that unalienable right to life. We stand firmly on the principle that from conception until the last breath is drawn, life is sacred.” Political Correctness is a doctrine, recently fostered by a delusional, illogical minority and promoted by a sick mainstream media, which holds forth the proposition that it is entirely possible to pick up a piece of shit by the clean end!
|
|
#14
10-25-2015, 04:32 PM
|
|||||
|
|||||
|
Pig was polite enough to point out to me this is a year old thread.
 But anyway he's moving sight the wrong way.
|
Linear Mode
