TAC Compact Ejection Port

[DrHenley]

John?

[Riverpigusmc]

Originally Posted by DrHenley

John?

Automag. Works for RIA, may be able to guide ya through the process

[Pawpaw]

My RIA compact is flared exactly the same way yours is and it does not dent the brass like that.

I suspect your extractor may be a little tight.

[sdmc530]

Originally Posted by Pawpaw

My RIA compact is flared exactly the same way yours is and it does not dent the brass like that.

I suspect your extractor may be a little tight.

I would agree but I am no smith. I would try to adjust your extractor it looks like its a bit tight.

[DrHenley]

Does altering the ejector and extractor constitute "Unauthorized Gunsmithing"???

(which voids the warranty)

"If the firearm was modified and/or repaired by an unqualified gunsmith without permission from Armscor, then the warranty will be void."

[Sheepdog]

I would not think adjusting the extractor would be considered gunsmithing.

[Riverpigusmc]

Originally Posted by DrHenley

Does altering the ejector and extractor constitute "Unauthorized Gunsmithing"???

(which voids the warranty)

"If the firearm was modified and/or repaired by an unqualified gunsmith without permission from Armscor, then the warranty will be void."

Bending the extractor to adjust tension won't void the warranty...filing on the ejector may. Dave Waits has an extensive thread on all this in the gunsmithing sub forum

[Sheepdog]

I already posted the link. I also PM'd John.