AR Doctrines 101 Class

[douglas_knott]

Originally Posted by USPSA Shooter

Ron, you can have a 14.5 inch barrel as long as the flash hider/comp is pinned to the barrel. That is what I have on mine.

Or a ten in with a six in flash hider.

[Big Smoke]

Thanks for the info, guys. I just picked up my lower receivers, and while I save some money, I have time to decide how I want to build them. One will be for short range, and one for longer range. I''m just trying to do all my homework on what's available to help make my decision.

[TLE2]

If it was going to be a 308 build, I'd be interested. I've seen several online videos even one from Brownells. The shared experience might add something however.

I'm a qualified "in".

[Roverron]

Ive never considered a pistol but this was from a friend who had sent a letter to BATF:

This refers to your letter of xxxxxxxxxx, in which you inquire
about the legality of manufacturing a handgun which utilizes a rifle
type receiver.

26 U.S.C. Chapter 53 # 5845(a)(4), the National Firearms Act (NFA),
defines the term "firearm" to include a weapon made from a rifle if
such weapon as modified has an overall length of less than 26 inches
or a barrel or barrels of less than 16 inches in length.

Utilizing the receiver of an existing rifle for the purposes of
manufacturing a handgun would constitute the making of a firearm as
defined above. Individuals desiring to make such a firearm must first
submit an ATF Form 1, Application To Make And Register a Firearm and
pay the applicable $200 making tax.

If an individual were to obtain a rifle type receiver that had not
previously been utilized in the assembly of a rifle, a handgun could be
made and not be subject to the provisions of the NFA. Verification
must be obtained from the manufacturer of the receiver to establish
its authenticity.

We trust the foregoing has been responsive to your inquiry. If we may
be of any further assistance, please contact us.

Sincerely your,
(signed)
M. Owen, Jr.
Chief, Firearms Technology Branch
-------------------------------------------
and there's this letter I've seen:

-------------------------------------------
So, from this Im assuming if the lower was registered originally as a Rifle, then Form 1 and $$$ is required to have it re-registered as a pistol lower. Does it require engraving on the lower to show as a pistol or ?? However, if you originally purchased the lower as a Pistol lower, then a Form 1 is Not required.

Is that correct? I might have to check into building one. cool looking pistol!

[RevM]

AR receivers are not recorded on forms 4473 as "rifles", they are simply "receivers".

You can build your receiver as a rifle or a pistol. Technically speaking, once it has been built into a rifle with a buttstock and upper attached it is only and forever a rifle unless you go the form 1 route to convert it to a pistol.

The exception is as your second ATF letter states ... if you buy a complete lower receiver with a buttstock attached you are allowed to remove the buttstock and replace it with a pistol buffer ... but once that complete lower is assembled with an upper it is forever a rifle (except form 1, yada, yada).