|
|
| Register | Forums | Blogs | Search | Today's Posts | Mark Forums Read | Donate |
 |
 |
 |
|
|
|
#2
02-17-2013, 09:34 PM
|
|||||
|
|||||
We built that room in Chuck's basement. We didn't even finish the inside Drywall!LOL! Bench is 8 feet long and 2 feet deep. All 2x8s and 4x4s. All fasteners are lagbolts,5/15ths.x2-1/2". One 2x6 crossbeam in center under table and all lags were countersunk. Those on the table were filled in with Clear Epoxy. Room measures 9'x12' inside. What isn't shown is a second wall Cabinet on Chuck's side for his powder/primers and his Gunsafe to the left of the Trimmer/Tumbler table.
Mike, both Powder measures are RCBS Uniflows, mine is a standard, Chuck's has the Micrometer charge-weight adjustment. My Rockchucker on the right, Chuck's RCBS, I think, Reloader Special press, on the left. his 505 scale on the left back of bench. The white Boxes and the large brown box on my side are full of bullets. The Pact Electronic sits right behind my side of the bench. The handiest piece of ewquipment outside of the Pact has to be the Lyman Electric trimmer. Has a PTO on the left side that takes screw in Primer-pocket brushes. You can clean a whole tray of case pockets in about four or five minutes with it.
__________________
Diligentia, Vis, Celeritas COTEP#CBOB0428 NRA,GCA,OGCA, USAF,Msgt.(Ret.) Last edited by Dave Waits; 02-17-2013 at 10:24 PM. 
|
|
#3
02-17-2013, 09:47 PM
|
|||||
|
|||||
|
Really nice setup, Dave. I can't wait to get mine all set up. Once I do, I'll post pics, too.
__________________
Dan Wesson CCO NRA Member "The things that we fear are a weapon to be held against us." - Neil Peart
|
 |
| Thread Tools | |
| Display Modes | |
Hybrid Mode