FMJ and LRN down the same barrel

[Lonestar grips.]

I shoot lead in my 1911's without any problems. as long as your lead isn't too soft and the bullets are sized correctly then you should be ok.

fyi, bevel base bullets are more prone to leading since gases can more easily get past the base and soften the lead causing it to streak. if the leading isn't too severe you can shoot a few jacketed bullets and it should clean out your barrel.

if you have severe leading then you can use Copper Chore Boy cleaning pads wrapped around an old bore brush for a snug fit. Make sure that you use the Chore Boy brand. The off brands may just be copper washed steel and scratch your barrel up.

[AFJuvat]

Lead bullets tend to suffer nose damage in sem-autos, reducing their accuracy.

Generally not a problem if the alloy is hard enough.

[Riverpigusmc]

I load and shoot lead. Like Dick Goesinya said, take a magnet with ya and buy real Chore Boy. Wilson Combat has a video about it

[Gatorade]

Thanks for the input. I cast using wheel weights and have been told that is harder than pure lead. I did shoot some FMJ through it but with free lead I will be shooting more .45 cast. I run them through a Lee .451 sizer. They come out with a flat base.

I was contemplating shooting lead in my M&P40C since I already have .401 dies from loading 38-40. However since that is my EDC I will keep it with just jacketed ammo. Untill I start experimenting with powder coating .401 cast lead and see that it won't lead my barrel. If I can get the powder coating down good then it would open up more casting for Blackout and others.

[Lonestar grips.]

wheel weights are plenty hard as is for range shooting (generally 9-10 BNH) but if you water drop them they'll be even harder.

powder coating is the best way to go nowadays.

if you're still learning about it I suggest you read through this thread. http://singleactions.proboards.com/t...ating-question

Dick Thompson aka Sixshot is a Major Handgun hunter and when it comes to cast bullets I trust his word over just about anyone else's.

[Lonestar grips.]

Tank Hoover knows a thing or two about it as well. http://americanhandgunner.com/homebr...-to-lube-them/

[sdmc530]

Dick Goesinya o busy out laughing every tome i read that.


I have loaded with lead but like already stated accuracy tanked for me so i dont unless its plated.