|
|
| Register | Forums | Blogs | Search | Today's Posts | Mark Forums Read | Donate |
 |
 |
 |
|
|
|
#1
01-24-2012, 04:43 PM
|
|||||
|
|||||
If it is sticking it can cause the problem. Insert a full mag and it could go full auto!!
It is good though that you only load 1 or 2 rounds after reassembly!! 
__________________
"This is the 44 Magnum AutoMag and holds a 300 grain cartridge and if properly used can remove the fingerprints"!! COTEP # CBOB0152 
|
|
#2
01-24-2012, 05:07 PM
|
||||
|
||||
|
Go witrh Automag that it could be disconnector issue. Cannot imagine bushing causing it. Only other thing is you might have disturbed clearance when you worked the GS? or bent the sear spring? (bending the left & middle fingers on sear spring will lighten trigger pull).
__________________
COTEP CBOB0297
|
 |
| Thread Tools | |
| Display Modes | |
Hybrid Mode