Changing the front sight on my S/A Range Officer

Big Smoke · #1 02-27-2012, 06:27 PM

I just bought a Hi-Viz sight to put on the front, but removing the stock dovetail sight is a bit confusing. It looks like there is a tiny allen screw at the front of the sight, I guess it's a lock-down pin or something like that, but it is smaller than my smallest allen wrench- 1/16th. Looks like half that size, like a 1/32 or something. Does anyone know exactly what size it is, and if it has to be loosened/removed before drifting out the dovetail?

MPrimo · #2 02-27-2012, 07:15 PM

Probably a roll pin (1/16") ... please look closely to verify. If it is, remove the barrel, bushing, etc and punch it through from outside to in. Same setup as Dan Wesson. If you properly fit and Loktite the new sight, you won't need it anymore.

Mike

MPrimo · #3 02-27-2012, 07:16 PM

BTW ... I have the HiVis front sight on a compensated Springer and I ABSOLUTELY LOVE IT!

Big Smoke · #4 02-27-2012, 11:20 PM

I was watching this video, and the guy says if it has the pin, you have to drill it out if you want to keep the sight for later use.

But then he says it's not a problem if you don't want to keep it, just drift it out, and the pin will shear off. Seems to me you can shear it off and drill it later, though it's probably easier to drill it while still on the slide. Before I do any drilling, I want to make sure I understand it right.

MPrimo · #5 02-28-2012, 08:12 AM

I have never had to drill one or shear one. I use a roll pin punch that is shortened to about 1/2 an inch. They generally come right out. Just did one on a Valor last week for a friend. I understand your trepidation though ... it might be best to bring it to a local shop if you are unsure ... don't mark up that beautiful pistol!

Big Smoke · #6 02-29-2012, 12:42 AM

I used a 1/16 drill bit to punch out the pin, then the sight came out with little exertion. I had to do a little fitting on the new sight, but I don't think it's the right one. Although the package said it was for a Springer, I don't think it's for a 1911. Looks to be for the XDm. But it fits for now, and until I get the right one, it's going to stay. It works great.
I broke the nylon punch on it, that I bought especially for the project. So I had to resort to brass, and as you know, brass leaves marks. After some scrubbing, I've got most of the brass marks out of it. I'll get the rest out this weekend, after I take it to the range and clean it.