Well, I have a high quality problem if you will. After fondling the Mono yesterday, I noticed that there appeared to be a gap on the right side frame to slide fit. At first it looks like an optical illusion. That maybe the serration (done by hand) is just missing from that area.
I was hesitant to post this as some people will tell me quit b*tching and just shoot the damn thing. Well, when you drop serious coin for something, you hope for a little more attention to detail.
Had this gun been sitting on a shelf at a dealer, would I have bought it with that flaw? Probably not, would you? I think not.
Well, a piece of 0.0035" thick and 0.154" wide "post it" says differently.[/B]
I can live with the even gap around the ejector, that I'm not questioning at all. My issue is with the gap between the frame and slide on the right side.
And yes, I noticed the munched serration on the bottom left side.
Again, My $1200 Kimber nor my $1100 Dan Wesson have any gaps like this.
Well, I emailed Les Baer yesterday and even called them this morning....NO response as of yet. From I remember reading in regards to their customer service, this is to be expected.
You be the judge!
